Panasonic Toughbook CF-07 Series Reference Manual

Also see for CF-07 Series: Operating instructions Operating instructions Service manual Reference manual Tips for use

Contents

39The power indicator orbattery indicator is not lit[Enter Password] is displayedPOST Startup Error(s) isdisplayedWindows startup, or anoperation is extremelyslowThe date and time are in-correctWhen the previous itemis not the causeThe cursor cannot becontrolledThe password is not re-quired when resumingfrom the standby or hi-bernation modeThe DISPLAY READY in-dicator does not go oneven when the HDD indi-cator goes offDealing with Problems (Advanced)When a problem occurs, power off the wireless display, then connect the optional port replicator (CF-VEB071), externalkeyboard and external display, and then refer to this page. If you still cannot troubleshoot the problem, contact PanasonicTechnical Support.Starting UpCheck the cable connection for the AC adaptor.Check to see if a fully charged battery is properly installed.Remove the battery pack and disconnect the AC adaptor, then connect them again.Input your password. If you have forgotten it, contact Panasonic Technical Support.page 37Press F9 in the Setup Utility ( page 29). This will restore the Setup Utility'ssettings to their default values (except the password settings). Then, the Setup Utilitymust be run once again for you to input the appropriate operating environment set-tings. (The processing speed depends on the application software used, so thisoperation may not cause the processing speed to increase.)You can set the date and time through [Date/Time] in [Start] - [Settings] - [ControlPanel].When the computer is connected to a Local Area Network (LAN), confirm the dateand time of the server.If you continue to experience problems, the internal battery maintaining the clockmay need to be replaced. Contact Panasonic Technical Support.This computer will not correctly recognize the date and time starting from the year2100 A.D.Press F9 in the Setup Utility ( page 29). This will restore the Setup Utility'ssettings to their default values (except the password settings).Try removing all peripheral devices.Windows 98Run SCANDISK to check the hard disk.At start-up, press Ctrl to operate the computer in the Safe mode.Windows 2000Click [Local Disk(C:)] in [My Computer] with the right button, select [Properties],then select [Tools] - [Check Now].At start-up, press F8 to operate the computer in the Safe mode.Restart the computer by using the keyboard (e.g., ).When the port replicator is not connected, turn off the computer.Use the Windows password as the following.Select [Start] - [Settings] - [Control Panel] - [Power Management]* - [Advanced],then the check mark for [Prompt for password when computer goes off standby].* Windows 2000 : [Power Options]Press the MENU button of the wireless display, then set the password ( Operat-ing Instructions of the wireless display).A problem possibly occurred during startup.After powering off the computer, connect the port replicator and restart the computer.Unable to shut down Win-dowsShutting DownDo not shut down Windows during music playback.