Panasonic Toughbook CF-52GGNBP2B Operating Instructions Manual

Also see for CF-52 Series: Supplementary guide Supplementary guide Supplementary instructions Getting started guide Supplementary instructions

Contents

22Troubleshooting (Basic)Getting StartedUseful InformationTroubleshootingAppendix“Remove disks or othermedia. Press any key torestart” or a similar mes-sage appears.z A floppy disk in the drive or USB memory is connected, and it does not contain sys-tem startup information. Remove the floppy disk and USB memory, then press anykey.z If a device is connected to the USB port, disconnect the device, or set [USB Port] or[Legacy USB Support] to [Disabled] in the [Advanced] menu of the Setup Utility.z If a device is connected to the ExpressCard slot, disconnect the device, or set [Express-Card Slot] to [Disabled] in the [Advanced] menu of the Setup Utility.z If the problem persists after removing the disk, it may be a hard disk failure. ContactPanasonic Technical Support (Î page 33).Windows startup and opera-tion is slow.z Press F9 in the Setup Utility (Î Reference Manual “Setup Utility”) to return theSetup Utility settings (excluding the passwords) to the default values. Start theSetup Utility and make the settings again. (Note that the processing speed dependson the application software, so this procedure may not make Windows faster.)z If you installed a resident software after purchase, turn off the residence.z Disable Indexing Service in the following menu.Click [start] - [Search] - [Change preferences] - [With Indexing Service (for fasterlocal searches)].The date and time are incor-rect.z Make the correct settings.Click (Start) - [Control Panel] - [Clock, Language, and Region] -[Date and Time].Click [start] - [Control Panel] - [Date, Time, Language, and RegionalOptions] - [Date and Time].z If the problem persists, the internal clock battery may need to be replaced. ContactPanasonic Technical Support (Î page 33).z When the computer is connected to LAN, check the date and time of the server.z The 2100 A.D. or later year will not be correctly recognized on this computer.[Executing Battery Recali-bration] screen appears.z The Battery Recalibration was canceled before Windows was shut down last time.To start up Windows, turn off the computer by the power switch, and then turn on.[Enter Password] does notappear when resuming fromsleep ( ) /standby ( )/hibernation.z Select [Enabled] in [Password On Resume] in the [Security] menu of the Setup Utility(Î Reference Manual “Setup Utility”).z The Windows password can be used instead of the password set in the Setup Utility.A Click (Start) - [Control Panel] - [User Accounts and Family Safety] - [Add orremove user accounts] and select the account, and set the password.B Click (Start) - [Control Panel] - [System and Security] - [Power Options] -[Require a password on wakeup] and add a check mark for [Require apassword].A Click [start] - [Control Panel] - [User Accounts] and select the account, and setthe password.B Click [start] - [Control Panel] - [Performance and Maintenance] - [Power Options]- [Advanced] and add a check mark for [Prompt for password when computerresumes from standby].Cannot resume. z An error may occur when the computer automatically enters the sleep or hibernationmode while the screen saver is active. In this case, turn off the screen saver or changethe pattern of the screen saver. Starting Up