108Fingerprint ReaderClick [start] - [Run] and input “c:\util\drivers\fngprint\install\32-bit\Setup.exe”, and click [OK].D Click [Next].Installation starts. Follow the on-screen instructions.E When the “Protector Suite *.* has been successfully installed.” message appears, click [Finish].At the confirmation message, click [Yes].The computer restarts.F Log on to Windows as an Administrator.The “Fingerprint software Icon” appears in the notification area.• If the icon does not appear, click .3 TPM Fingerprint Utility InitializationPerformed by the Computer Administrator.The “Invalid TPM status” message is displayed by the “Fingerprint software Icon” in the notification area.• If the icon does not appear, click .z If the TPM is not being used, skip this step.A Click on the “Invalid TPM status” message and then click [Initialize].Follow the on-screen instructions.NOTEz If the “Invalid TPM status” message is not displayedClick (Start) / [start] - [All Programs] - [Protector Suite] - [Control Center] - [Settings] -[Advanced Settings] - [Trusted Platform Module (TPM)] - [Initialize]. And then click (Start) - [All Programs] -[Protector Suite] - [Control Center] - [Identity] - [Multifactor], and choose a method of authentication.4 User Fingerprint EnrollmentPerformed by each user.A Double-click the “Fingerprint software Icon” .• If the icon does not appear, click .B If the License Agreement appears, carefully read it, and then click [Accept].C Select an enrollment mode, if so required, and click [Apply].z Enrollment modeYou can make the configuration for the enrollment only once during this initialization phase.• Enrollment to the biometric deviceAll enrolled fingerprints are stored directly in the fingerprint sensor. The user data will be secured by thehardware protection keys obtained by the fingerprint sensor. There is a limit to the number of fingerprintsthat can be enrolled.Windows XPWindows 7 Windows XP