Panasonic Toughbook CF-W4GWCZZBM Operating Instructions Manual

Also see for CF-W4 Series: Operating instructions Reference manual

29 Getting StartedSetup UtilityThe Setup Utility sets the computer's boot-up operating environment, i.e. passwords,startup drive, etc. The following six menu items are available:[Information], [Main], [Advanced], [Security], [Boot], [Exit]1 Turn on or restart the computer.2 Press the F2 key while [Panasonic] boot screen is displayedsoon after the computer begins the startup procedure.When the password is set, the screen shown at left will be displayed. Enteryour password, and press the Enter key.When inputting the Supervisor Passwordz You can register all items of the Setup Utility.When inputting the User Passwordz On the [Advanced] and the [Boot] menu:• You can view the settings, but cannot change it.z On the [Security] menu:• The following will not be displayed: [Clear registered SD card], [SetSupervisor Password] and [Hard Disk Lock].• The following will be displayed, but cannot be set: [Execute-DisableBit Capability], [Password on boot], [SD Startup], [SD SettingMethod], [Setup Utility Prompt], [Boot First Menu], and [User Pass-word Protection].• The User Password can be changed only when [User Password Pro-tection] has been set to [No Protection]. The User Password cannotbe deleted.z On the [Exit] menu:• [Get Default Values] option will not be displayed.z The F9 key does not work.NOTEz Cannot display the Setup Utility screen in simultaneous display.By pressing the Fn+F3 key, display destinations can be changed either exter-nal display or the internal LCD.z When [Password on boot] in the Setup Utility is set to [Disable]:• When the computer is started up, entering a password is not necessary.• When the Setup Utility is started up:The password becomes necessary. This alternative can prevent the contentsof the Setup Utility from being changed.z If you fail to press the F2 key at the right moment, the Setup Utility will not startup. In this case, let the computer fully boot up, and then perform a shutdown orrestart from Windows.z To close the Setup Utility:A Press the Esc key.B Select the exiting method from the [Exit] menu and press the Enter key.C Select [Yes] and then press the Enter key.Running the Setup Utility