19 Getting StartedUseful InformationTroubleshootingAppendixCAUTIONz You will be unable to set [Computrace (R) BIOS Module] to [Disable] once you have set to [Enable]. Do not changethe setting when not used.• Even if you have set [Computrace (R) BIOS Module] to [Enable], this setting may return to [Disable] after repairs tothe motherboard, etc. have been made.NOTEz Consult Absolute Software Corp. before disposal.z Refer to the following URL for Computrace ® software for installation and available service regions. Note that thisservice is only available in certain regions.http://www.absolute.com1 Turn on or restart the computer, and press F2 while [Panasonic] boot screen is dis-played.The Setup Utility starts up.z If the password is requested, enter the Supervisor Password.2 Select the [Security] menu, then select [Computrace (R) Sub-Menu] and press Enter.3 Select [Computrace (R) BIOS Module], and set to [Enable].4 At the confirmation message, select [Execute] and press Enter.5 At the reconfirmation message, select [Execute] and press Enter.6 Press F10.At the confirmation message, select [Yes] and press Enter.The computer restarts.To clean the LCD panel and touch padWipe lightly with a gauze or other dry, soft cloth.To clean areas other than the LCD panel and touch padWet a soft cloth with water or a diluted kitchen cleanser (neutral), wring the cloth out thoroughly, and wipe the dirty areagently. Using a detergent other than a neutral kitchen cleanser (e.g., a weak alkali cleanser) may adversely affectpainted surfaces.CAUTIONz Do not use benzene, thinner, or rubbing alcohol since it may adversely affect the surface causing discoloration, etc.Do not use commercially-available household cleaners and cosmetics, as they may contain components harmful tothe surface.z Do not apply water or detergent directly to the computer, since liquid may enter inside of the computer and causemalfunction or damage.Maintenance