Setting the Unit30It is possible to set the current time for the unitclock.Note• The time and date are set using the followingprocedure (for example, in the order month, day,year, hour, minute). The setting sequence will bedifferent depending on country/area. The statusof the Remaining Film and Contrast Indicatorswill show which item is being set.1 Press .• The unit will switch to setting mode, and“ ” is displayed in the Display Window.2 Press or to select “ ”.3 Press .• The “month” value is displayed in the DisplayWindow.4 Press or to set the “month”.• When the “month” is set, the Remaining FilmIndicator will be on.Press .• The “day” value is displayed in the DisplayWindow.5 Press or to set the “day”.• When the “day” is set, the Contrast Indicatorwill be on.Press .• The “year” value (last two digits of theWestern calendar) is displayed in the DisplayWindow.6 Press or to set the “year”(last two digits of the Westerncalendar).• When the “year” is set, the Remaining FilmIndicator and Contrast Indicator will be on.Press .• The “hour” value is displayed in the DisplayWindow.7 Press or to set the “hour”.• When the “hour” is set, the Remaining FilmIndicator will flash.Press .• The “minute” value is displayed in the DisplayWindow.8 Press or to set the “minute”.• When the “minute” is set, the ContrastIndicator will flash.Press .• After the time has been set and the set timehas been displayed in the setting sequence,the Display Window returns to showing “ ” .9 Press .• The unit will return to ready mode.Note• Pressing during current time setup (steps4 to 8) will cancel the previous operations andreturn the unit to the time prior to setup.• If you press and hold or , the numberwill change in increments of 10.Setting the current timeE.g. FebruaryContinuous light(orange)Continuouslight (green)E.g. 15thContinuous light(orange)Continuouslight (green)E.g. 2013Flashing light(orange)E.g. 17:00Flashing light(green)E.g. 30 minutes