126UF-9000JAN 2004Ver. 1.0DP-180/1904.8. Information Code Table (For Facsimile)Fax Information CodesCode Mode Phase Description of Problem Cause001 RCVCOPYC, D Leading edge of the recordingpaper fails to reach the TimingSensor. (1st Tray)Recording paper jam.Timing Sensor abnormal.002 RCVCOPYC, D Leading edge of the recordingpaper fails to reach the TimingSensor. (2nd Tray)Recording paper jam.Timing Sensor abnormal.007 RCVCOPYC, D 1. Leading edge of the recordingpaper fails to reach the PaperExit Sensor.2. Recording paper has notcompletely passed the PaperExit Sensor.Recording paper jam.Paper Exit Sensor abnormal.008 Paper Tray is opened while paperis feeding.Paper Tray is opened.010 RCVCOPYB, C No recording paper. No recording paper or paper is not setproperly.No Paper Sensor is defective.011 STANDBY B, C Paper Tray is not installedproperly.Connector is not installed properly.012 RCV C, D The length of the receiveddocument is over 2 m.Transmitter Document Jam.017 Incorrect paper size loaded in thePaper Tray.Paper size is incorrect.030 XMT B Read Point Sensor does not goON within 10 seconds after thedocument starts feeding.Document is not set properly.Defective Read Point Sensor.031 XMTCOPYC Transmitting document was longerthan 2 meter (or 78.7 in).The document may jam.Defective Read Point Sensor.041 STANDBYRCVCOPYB, C, D Out of Toner. No toner.Defective Low Toner Sensor.043 STANDBYRCVCOPYB, C, D Low Toner. Toner is getting low.Defective Low Toner Sensor.045 STANDBY - No Toner Cartridge. Toner Cartridge has not been installed.Defective Toner Cartridge Sensor.060 - A Printer Cover is open. Cover is not firmly closed.Connectors are not firmly connected.061 - A ADF Door is open. Door is not firmly closed.Connectors are not firmly connected.400 XMT B T1 timer (35 ± 5 sec.) elapsedwithout detecting 300 bps signal.Incorrect number was dialed and theSTART button was pushed.Telephone line was disconnected whiledialing.SC PCB (Modem) or MJR PCB aredefective.Receiver is defective. (It may only betransmitting CED)