IndicationsOthers100LSQT1052It is possible that the system cannot complete writing of a file normally when, for example, power isturned off for some reason during recording or editing.If faulty management information is found when a disc is accessed, the following message mayappear. Be sure to follow the messages. (Repairing may take time depending on the error.)≥ When you repair the disc, use a battery withsufficient battery power or the AC adaptor.≥ Depending on the condition of the data, it may notbe possible to completely repair the data.≥ If the disc is removed without it being repaired, youwill no longer be able to playback the scenesrecorded before the power went off.≥ Do not repair a disc that has been recorded onanother device. This may cause the loss of data orthe disc.CHECK CARD. This card is not compatible or it cannot be recognized by theunit.CARD LOCKED. The write protection switch on the SD Memory Card is set toLOCK. (l 16)CARD FULL. The SD card is full so no further data can be recorded. Deleteunnecessary files (l 77) or insert a new SD card.PUSH THE RESETSWITCH.An irregularity in the unit has been detected. Press the RESETbutton to restart the unit. (l 106)CHANGE TO MANUALMODE. You are attempting to use a function that cannot be usedsimultaneously.CANCEL NIGHT VIEWMODECHANGE MODE TO USEUSB. The USB cable is connected in the recording mode.DISCONNECT USBCABLE.The unit cannot correctly establish the connection to thecomputer or printer. Disconnect and then reconnect the USBcable or check the [USB FUNCTION] setting on this unit.About recoveryDISC ERROR HAS OCCURRED. REPAIR DISC NOW?LSQT1052(ENG).book 100 ページ ２００５年１２月２１日 水曜日 午後６時５０分
