Panasonic VIERA TH-40D400A Operating Instructions Manual

Also see for VIERA TH-40D400A: Operating instructions

Initial Setup | Operating the TV9Initial SetupWhen you first turn on the TV, a series of steps will pop-up to guide you to setup your TV.●These steps are not necessary if the setup has beencompleted by your local dealer.1 Plug the mains plug into the socketoutlet and turn on the TV.It may take a few seconds before the screen isdisplayed.AC 220 - 240 V,50/60 HzProceed to steps 2, 3 and 4.Scanning starts automatically whenyou turn on the TV (step 3). After scanning iscompleted, proceed to step 4.2 Select your area.New South Wales/Australian Capital TerritoryVictoriaQueenslandSouth AustraliaWestern AustraliaNorthern TerritoryTasmaniaSelect State/TerritoryOKAccessSelect3 Scanning starts.[Automatic Channel Search][Auto Tuning]Example:Automatic Channel SearchStatus: Scanning...Analogue : 0Digital : 1EXITRETURNScan 5%●This function searches and stores TV channels.●The stored channels and sorted channel order varydepending on the area, broadcasting system andconditions of signal reception.4 Select [Home].Please select your viewing environment.Home ShopOKConfirmChange●[Shop] is for shop display.●To change the viewing environment later on, youneed to initialise all settings by accessing [ShippingCondition] (p. 15).Setup is now complete and your TV is ready forviewing.Note●If tuning has failed, check the connection of the RFcable, then follow the on-screen instructions.Operating the TVUsing the TV controlsIndicators on the TV5 6 713241 Changes the input modeDisplays [Main Menu] when press and hold for3 seconds● Press again and hold for 3 seconds to return to theprevious screen from submenus / exit from mainmenu page.2 Channel Up / DownCursor Up / Down● Makes selections in the menu system.3 Volume Up / DownCursor Left / Right● Makes selections and / or adjustments when in themenu system.4 Mains power On / Off switch● Use to switch the mains power.5 Remote control signal receiver6 C.A.T.S. (Contrast Automatic Tracking System)sensor● Senses brightness to adjust picture quality when[Eco Mode] in the [Picture] menu is set to [On].(p. 8)7 Power LED● Red: StandbyGreen: On● The LED blinks when the TV receives a commandfrom the remote control.