Panasonic VL-MN1000 Installation And Operating Instructions Manual

6.3 Configuring each arm modeYou can select which alarm features are enabled anddisabled for each arm mode.1 From the home screen, tap “Alarm”.2 Tap “Mode Settings” on the left side of the screen.3 Enter the user password and then tap “OK”.R The default user password is "123456".R This password is determined by the “User PW”setting (8.1 Changing the room monitor’s settings(Page 23)). We recommend changing this andall passwords regularly.4 Select the tab that corresponds to the arm mode youwant to edit.5 Tap each alarm feature (“Alarm 1”–“Alarm 6”) toturn them on or off for the selected arm mode.6 When finished, tap .6.4 Changing alarm featuresettings1 From the home screen, tap “Alarm”.2 Tap “Alarm Status” on the left side of the screen.3 Select the desired alarm feature and then tap“Set”.R To quickly remove or bypass an alarm feature,tap “Off” or “Off(Once)” instead of “Set”.4 Enter the user password and then tap “OK”.R The default user password is "123456".R This password is determined by the “User PW”setting (8.1 Changing the room monitor’s settings(Page 23)). We recommend changing this andall passwords regularly.5 Select the desired field, change the setting asdesired, and then tap “OK”.R For details about each setting, see Alarm featuresettings (Page 20).6 When finished, tap .Alarm feature settings– “Alarm No.”: Indicates the alarm feature number.Cannot be changed.– “Device Type”: Allows you to set the type of devicethat is connected. This setting affects the waynotifications are displayed when this device istriggered. This setting cannot be changed for“Alarm 1”–“Alarm 3”.– “NO/NC”: This setting should match thespecifications of the device. Select “NO” if the deviceis normally open; select “NC” if the device is normallyclosed.– “Timing”: Determines how quickly the device’sdetection is acted upon. The following settings areavailable.R “No-delay Alarm”: The notification will be sentas soon as the device is triggered.R “Delay Alarm”: There will be a delay before thealarm feature is enabled or before the notificationis sent. Select this setting if you want to use“Entry Delay” or “Exit Delay”.R “Off” (available only when alarm features aredisabled): The alarm feature is disabled.R “Off(Once)” (available only when alarmfeatures are disabled): The next time the alarmfeatures are armed, the alarm feature will bedisabled. After the alarm features are disarmedand armed again, the setting returns to itsprevious setting.– “Entry Delay”: When the arm mode is “Out”, theentry delay can give you time to change the armmode when you return home. Available only when“Timing” is set to “Delay Alarm”.206. Alarm features