Panasonic Viera TH-42PX600 Operating Instructions Manual

Also see for TH-42PX600U: Technical guide Service manual Technical guide Operating instructions Operating instructions

7Quick Start Guide Accessories/Optionsba ABBAttaching the pedestal to the plasma televisionCautionDo not use any television or displays other than those given in this manual.• Otherwise the unit may fall over and become damaged, and personal injury may result.Do not use the pedestal if it becomes warped or physically damaged.• If you use the pedestal while it is physically damaged, personal injury may result. Contact your nearest PanasonicDealer immediately.During setting-up, make sure that all screws are securely tightened.• If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong enough tosupport the plasma television, and it might fall over and become damaged, and personal injury may result.Use the accessory fall-prevention brackets to secure the plasma television.• If the unit is knocked or children climb onto the pedestal with the Plasma TV installed, the plasma television mayfall over and personal injury may result.Two or more people are required to install and remove the television.• If two people are not present, the television may be dropped, and personal injury may result.1 Assembling the pedestalWarningDo not disassemble or modify the pedestal.• Otherwise the unit may fall over and become damaged, and personal injury may result.A Assembly screw(4) D Base (1)B Assembly screw(4) E Band (2)(for 42˝ and 50˝) M5 x 18(for 58˝) M5 x 25 M5 x 65C Pole (2)Using the four assembly screws A , securely fasten the left and right poles to the base, as shown in theillustration below.PoleFrontPole( ) Pole( )Pole FrontAlign the stamped marks. Align the stamped marks.Accessories for pedestal assembly2 Setting-upLift the television unit above the pedestalbase, with the back of the display unit onthe same side as the Label. Then align theholes in the television unit with the poles ofthe pedestal and lower the television unit intoplace.Use the assembly screws B (M5 x 65) tofasten securely.Television unitPedestalLabel* Carry out work on a horizontal and level surface.Rear