-14-OPERATING PROCEDURESShown below is the keyboard layout of the AD equipment.AD2078 Series Keyboard LayoutSTATUS MONITOR1 0 2 41 2 8 6 4LASTARMOFFPROGUSEROFFPROGDISPSITEF1 F2 B-PAS ACKNEXT RUN HOLDSALVO CAMERACAMERA ENTERMONITOR2 315 648 907CLEAR WIDE TELEZOOMFOCUSIRISAUXILIARY PRESETNEAR FARCLOSE OPENOFF ON CALL SETEXITPAGEENTERPAGEn Monitor Selection1. Select the desired monitor by pressing the Numerickeys, then press the MONITOR key.For example, press 1, then press the MONITOR keyto select monitor 1.n Camera Selection1. Select the desired monitor referring to the MonitorSelection.2. Select the desired camera address by pressing theNumeric keys, then press the CAMERA key.For example, press 1, then press the CAMERA keyto select camera 1 on the selected monitor.n Controlling System Accessoriesl Lens Control1. Select the desired camera referring to the CameraSelection.2. Press the FOCUS NEAR/FAR keys to adjust thelens focus to obtain a sharply focused picture whileobserving the monitor.Select 1 by pressing the Numeric key, then pressthe AUXILIARY ON key to adjust the lens focusautomatically, if you are using the specified camerawith auto focus feature.3. Press the ZOOM WIDE/TELE keys to adjust the lenszoom to obtain the desired picture while observingthe monitor.Press the TELE key to optically bring an object clos-er.Pressing the WIDE key has the reverse effect.4. Press the IRIS CLOSE/OPEN keys to close or openthe lens iris.Adjust the lens iris by using the keys to obtain theproper picture exposure.l Pan/Tilt Control (Manual Operation)1. Select the desired camera referring to the CameraSelection.2. Move the Joystick Controller to move the pan/tilthead in the desired direction.l Pan/Tilt Control (Auto Panning Operation)The following functions are available only with camerasthat have auto panning functions, such as thePanasonic WV-CS600 series and when the DIP switch isset to CAM position.1. Select the desired camera referring to the CameraSelection.2. Select 2 by pressing the Numeric key, then pressthe AUXILIARY ON key to activate the auto panningfunction.3. To cancel the auto panning function, select 2 bypressing the Numeric key, then press the AUXIL-IARY OFF key.Note: If the AUTO MODE is selected to activate thecamera, make sure to select LOCAL for theLOCAL/REMOTE parameter.