Panasonic WJ-GXE900 Operating Instructions Manual

Also see for WJGXD900 - MPEG2 DECODER: Brochure

Contents

Panasonic WJ-GXE900 Operating Instructions Manual Manual pdf 30 page image

30Installing in a container box (Only for the Encoder)The encoder can be installed in a container box.When required to install the encoder in a container box, install as below.How to install1. Place the supplied simple mounting brackets with thesupplied fixing screws on the bottom of the encoder.2. Fix the encoder in the container box by fixing the attachedsimple mounting brackets to the box with fixing screws.(Procure fixing screws locally to fix the encoder in thecontainer box according to the material of the box.)Warning when installing the encoder in a container boxTo reduce the risk of fire or malfunction, observe the following instructions.1. Ensure the following when installing the encoder in the box.• Do not block the ventilation openings at the rear, on the bottom of the encoder with cables or clothes etc.• Keep more than 10 cm distance between the rear panel of the encoder and the internal side surface of the box.• Keep more than 1 cm between the bottom of the encoder and the internal bottom surface of the box.2. Keep the temperature inside the box between –5 °C and +45 °C (23 °F and 113 °F) and the humidity less than 90%while the encoder is in operation. (Recommended temperature is less than 40 °C (104 °F).If temperature and humidity are beyond the value above, it may affect parts inside of the encoder and causemalfunction.In case of installing the container box outdoor, consider influences on temperature and humidity from seasonalchange, sunlight and weather.According to needs, fabricate sun shields, cooling devices, heating devices, drain holes, etc.3. Do not install the box in places where discharging of corrosive liquids and gases occurs such as locations close toseawater, hot springs, exhaust gas, etc.This may cause corrosion of internal parts inside of the encoder.4. In case of installing the box in place exposed to rain, use the waterproof box equivalent to the IP45 or better.Waterproof also around the cable hole and the cables as sufficiently as possible.5. Depending on the material of the box, it may cause noise as the result of the vibration of the cooling fan of theencoder with the box.6. Make enough space around the rear panel and fix the cables firmly but so as not to bend the cables or place toomuch force on the connectors.7. Do not install the box in places such as in a car which is subject to having strong vibrationsSimple mounting bracket for thecontainer box (supplied)Fixing screw for the simplemounting bracket (M3x6: supplied)Procure fixing screws locallyaccording to the material of the box.INSTALLATIONSINSTALLATIONS