Panasonic WJ-ND400K Setup Instructions

Also see for WJ-ND400K: Operating instructions Manual Specification Setup instructions Specification sheet

Contents

Panasonic WJ-ND400K Setup Instructions Manual pdf 27 page image

271 Click the [Quick] button.The "Quick" page will be displayed.2 Configure each setting item.Refer to "Setup items" mentioned below.3 Click the [Set] button in the "Network setup"section.When the IP address of the client PC port ischanged, the following window will be displayed.Click the [OK] button to apply the setting.Note:• When the IP address of the client PC port ischanged, all login users will forcibly be logged out.It is necessary for users to access the changed IPaddress to reconnect to the recorder.• When the "Line speed" setting is changed and the[Set] button is clicked, the recorder will reboot.Network settingsConfigure the network settings of the recorder.■ Network setup - Camera port/Client PC portConfigure the following setting items for each port.[DHCP]Select "On" or "Off" to determine whether or not to usethe DHCP server.Select "On" to obtain an IP address, a subnet maskand a gateway address from the DHCP server. Select"Off" when entering values manually.On: Uses the DHCP server.Off (default): Does not use the DHCP server.[IP address] *1When "Off" is selected for "DHCP", enter an IPaddress.[Subnet mask] *1Enter a subnet mask according to the network configu-ration when "Off" is selected for "DHCP".[Default gateway] *1Enter the address of the default gateway according tothe network configuration when "Off" is selected for"DHCP".[Line speed]The following are available for "Line speed".Auto (default)/1000M-Full/100M-Full/100M-Half/10M-Full/10M-Half■ Network setup - Maintenance port[IP address] *1Enter an IP address.[Subnet mask] *1Enter a subnet mask.*1 Refer to page 11 about the default setting.Important:• The network settings for each port (IP address, etc.)should be configured with a different subnet.• When "On" is selected for "DHCP" and any framerate other than "Off" is select for "SD memory rec.",a request for writing data onto the SD memory carddemanded at the startup of the recorder may fail.This error may occur when the response from theDHCP server is slow.However, a request for writing data onto the SDmemory card will be accepted once the addresseshave been obtained from the DHCP server.Setup items