Panasonic WJ-ND400K Setup Instructions

Also see for WJ-ND400K: Operating instructions Manual Specification Setup instructions Specification sheet

Contents

Panasonic WJ-ND400K Setup Instructions Manual pdf 39 page image

39• Record a logA log that contains the event type and the time anddate of the event occurrence will be recorded.(Event log)• Send recorded images to an FTP server at an eventoccurrenceWhen an event occurs, recorded images will becontinued transmitting to an FTP server automati-cally for the set duration from the time when theevent occurred. Refer to the "Time table" section onpage 47 and the "FTP" section (page 58) for infor-mation about the settings.• Notify a PC of an event or an error occurrence usingthe Panasonic alarm protocolWhen an event or an error occurs, information aboutthe event/ error will automatically be notified to theregistered PC according to the "Panasonic alarmprotocol" setting. To receive a notification and dis-play the contents of it, it is necessary to install theoptional dedicated software*.* Refer to the "readme.txt" on the provided CD-ROMabout the dedicated software.■ Alarm outputSelect the alarm output duration.The following are available for alarm output duration.Off/2s (default)/5s/10s/20s/30s/1min/Ext/RecOff: No alarm output will be supplied.Ext.: The alarm output will continue until the [ALM] but-ton is clicked.Rec.: The alarm output will be supplied during eventrecording is being performed.■ Buzzer durationSelect the buzzer duration at an event occurrence. Thefollowing are available for buzzer sounding duration.Off/2s (default)/5s/10s/20s/30s/1min/Ext/RecOff: The buzzer will not sound.Ext.: The buzzer will continue sounding until the [ALM]button is clicked.Rec.: The buzzer will sound only during the eventrecording is being performed.Setup itemsBasicSet the alarm output duration and the buzzer sounding duration starting at an event occurrence (site alarm, terminalalarm and command alarm).1 Click the [Event] button.2 Click the [Basic] tab.The "Basic" page of "Event" will be displayed.3 Configure each setting item.Refer to "Setup items" mentioned below.4 Click the [Set] button.