26How to use the terminals of the ALARM/CONTROL connectorThis connector is used when connecting an external device such as a sensor that outputs alarm signals or when installing anexternal alarm device such as a buzzer or a lamp. The connector to be used should be compatible with the pin array.Pin arrayThe pin array is different from other Panasonic recorders. Make surethat the connection is correct referring to the following.Pin No. Signal Operation Remarks1 Alarm input 1 Event action will be performed according to thesettings.Non-voltage make contact, 5 Vpull-up/−100 mA2 Alarm input 23 Alarm input 34 Alarm input 45 Alarm input 56 Alarm input 67 Alarm input 78 Alarm input 89 Alarm input 910 Network error output Signal output upon detection of a brokenEthernet linkOpen collector output, 24 V DCmax., –100 mA11 Alarm reset input Canceling the alarm display Non-voltage make contact, 5 Vpull-up/−100 mA12 N/A13 Signal ground14 Signal ground15 Face matching output Signal output at the occurrence of a face match-ing alarmOpen collector output, 24 V DCmax., –100 mA16 HDD error output Signal output upon detection of an HDD error17 Camera error output Signal output upon detection of a camera error18 Recorder error output Signal output upon detection of a recorder error19 Recording error output Signal output upon detection of a recording error20 Time adjustment signal input According to the signal input from the otherdevice, the time of this recorder will be adjustedto the hour (00 minutes 00 seconds).Non-voltage make contact, 5 Vpull-up/−100 mA21 Alarm output Alarm signal will be supplied at an event occur-rence (Except for a face matching alarm)Open collector output, 24 V DCmax., –100 mA22 N/A23 N/A24 N/A25 +5 V output +5 V output 200 mA max.About the connector11325 14ALARM/CONTROL
