Panasonic WV-BP550 Operating Instructions Manual

Also see for WVBP550 - CCTV CAMERA: Operating instructions Specifications

Contents

-26-5. The VS gen-lock mode has its own menu for hori-zontal phase adjustments. When the cable lengthof the video output or the gen-lock input ischanged, the horizontal phase must be re-adjust-ed.6. The line-lock mode has its own menu for line-lockvertical phase adjustment. If the camera installa-tion is relocated, check the vertical phase adjust-ment again since the AC line phase may be differ-ent.6-1. VS Gen-lock Mode (EXT(VS))1. Move the cursor to the SYNC parameter andselect INT.2. Connect the coaxial cable for the composite syncor composite B/W video signal to the gen-lockinput connector.3. Confirm that the parameter INT changed to EXT(VS) on the menu.Caution: The gen-lock input signal should meetwith EIA RS-170 specifications and should notcontain jitter, such as a VCR playback signal ,as it could disturb synchronization.4. After confirming the cursor is on EXT (VS), press. The phase adjustment menu appears on themonitor.** CAM SET UP **CAMERA ID OFFALC/ELC ALCSHUTTER ---AGC ONSENS UP OFFSYNC INTMOTION DET OFFLENS DRIVE DCEND SET UP ENABLE↵↵↵** CAM SET UP **CAMERA ID OFFALC/ELC ALCSHUTTER ---AGC ONSENS UP OFFSYNC EXT(VS)MOTION DET OFFLENS DRIVE DCEND SET UP ENABLE↵↵↵** SYNC **H PHASE ........I- +RET END5. Move the cursor to H PHASE. The cursor startsblinking.6. Supply the video output signal of the camera to beadjusted and the reference gen-lock input signalto a dual-trace oscilloscope.