Panasonic WV-CU161C Operating Instructions Manual

Also see for WVCU161C - SYSTEM CONTROLLER: Product catalog Specifications

Panasonic WV-CU161C Operating Instructions Manual Manual pdf 20 page image

• Closing Setup MenuPress the PRESET/SET/PROGRAM PRESET button for 2seconds or more while the SHIFT indicator is lit.The SETUP indicator goes off.Note: The new settings are not saved if the WV-CU161C power is turned off before completing thesetup. Return to the WV-CU161C SETUP MENU,complete the setup, and then turn the power off tosave the new settings. Alarm SetupAlarm related functions are set up.1. Display the WV-CU161CC SETUP MENU.2. Move the cursor to ALARM SETUP , and then pressthe SET button.The setup menu appears depending on the ALARMswitch setting on the rear of the controller.ALARM PRESET appears on the bottom of the menuwhen the ALARM switch is set to the upper position toconnect with a time lapse VCR.ALARM TERMINAL appears on the bottom of themenu when the ALARM switch is set to the lower posi-tion to connect with four sensors.Alarm Display SettingThis item lets you select whether or not to display an“ALARM” text line on the monitor when an alarm is activat-ed.1. Display the ALARM SETUP menu.2. Move the cursor to ALARM DISPLAY.3. Select ON or OFF using the joystick, and then press theSET button. The factory setting is ON.ON: Display is enabled.OFF: Display is disabled.20Note: The display time differs depending on the AlarmOutput Setting.Site Alarm SettingThis item lets you enable or disable the controller to receivethe camera site alarm.1. Display the ALARM SETUP menu.2. Select SITE ALARM by moving the joystick up or down.3. Select SITE ALARM ON or OFF by moving the joystickto the right or left.The initial factory setting is ON.ON: The controller receives the site alarm (Video MotionDetection: VMD) issued by the camera.OFF: The site alarm is disabled.Terminal Alarm SettingThis item lets you enable or disable the controller to receivethe alarm signal from the alarm connector.1. Display the ALARM SETUP menu.2. Select TERM.ALARM by moving the joystick up ordown.3. Select TERM.ALARM ON or OFF by moving the joystickto the right or left.The initial factory setting is ON.ON: Alarm activation through the terminal is received.OFF: Alarm activation through the terminal is noreceived.Alarm Output SettingThis item lets you select the duration that the following threefunctions continue working for after an alarm activation.• The ALARM is displayed on the monitor (ALARM DIS-PLAY ON mode).• The alarm is output to external devices (from theALARM OUTPUT connector).• The buzzer sounds (ALARM BUZZER ON mode).1. Display the ALARM SETUP menu.2. Select ALARM OUTPUT by moving the joystick up ordown.3. Select the desired alarm output duration of 1S-30S,40S, 50S, 1MIN, 2MIN, 3MIN, 4MIN, 5MIN EXT or OFFby moving the joystick to the right or left.The initial factory setting is 10S.EXT: The alarm signal continues to be output from thealarm output connector until the alarm is reset. Thealarm is not automatically reset.1S-5MIN: The alarm signal is only supplied from thealarm output connector for the set time. The alarm isautomatically reset after the set time. The ALARMindicator changes from blinking to a steady light.OFF: No alarm output signal is supplied. (The alarm isdeactivated.)ALARM SETUPALARM DISPLAY ONSITE ALARM ONTERM.ALARM ONALARM OUTPUT 10SALARM BUZZER ONALARM PRESET –ALARM SETUPALARM DISPLAY ONSITE ALARM ONTERM.ALARM ONALARM OUTPUT 10SALARM BUZZER ONALARM TERMINAL