Panasonic WV-CW384 Operating Instructions Manual

Also see for Super Dynamic III WV-CW384: Product catalog Product catalog Brochure & specs Brochure & specs Operating instructions

Contents

Panasonic WV-CW384 Operating Instructions Manual Manual pdf 7 page image

7This product has no power switch.Power is supplied from an external 12 V DC/24 V ACpower-supply device. Refer to service personnel for how toturn on/off the power.To keep on using with stable performance• Parts of this product may deteriorate and it may shortenlifetime of the product when using in locations subjectto high temperatures and high humidity.Do not expose the product to direct heat such from aheater.• Use this product at temperature within –30 °C to +50 °C{22 °F to 122 °F}* and humidity below 90 %.* –10 °C to +50 °C {14 °F to 122 °F} at 12 V DCDo not drop metallic parts through slots.This could permanently damage this product. Turn thepower off immediately and contact qualified service per-sonnel for service.Do not rub the edges of metal parts with your hand.Failure to observe this may cause injury.Do not attempt to disassemble this product.To prevent electric shock, do not remove screws or covers.There are no user-serviceable parts inside.Ask qualified service personnel for servicing.Handle this product with care.Do not abuse this product. Avoid striking, shaking, etc.The product could be damaged by improper handling orstorage.Cleaning this product bodyTurn the power off when cleaning the product. Use a drycloth to clean the product. Do not use strong abrasivedetergent when cleaning the product body. When the dirt ishard to remove, use a mild detergent and wipe gently.Then, wipe off the remaining detergent with a dry cloth.Otherwise, it may cause discoloration. When using a chemi-cal cloth for cleaning, read the caution provided with thechemical cloth product.Clean the lens with care.Do not clean the lens with strong or abrasive detergents.Use lens tissue or a cotton tipped applicator and ethanol.Discoloration on the CCD color filterWhen continuously shooting a bright light source such as aspotlight, the color filter of the CCD may have deterioratedand it may cause discoloration.Even when changing the fixed shooting direction after con-tinuously shooting a spotlight for a certain period, the dis-coloration may remain.PrecautionsDo not aim this product at strong light sources.A light source such as a spot light causes a blooming (lightbleeding) or a smear (vertical lines).About the dehumidifying device• This product has dehumidifying device to keep theinside at low moisture level, preventing condensationand quickly dissipating dew if produced.• Dew may be produced depending on the conditions oftemperature, humidity, winds, and rain, and it may taketime to dehumidify.• Never seal the surfaces of the dehumidifying device.Turn the circuit breaker off which supplies this productwith the power when abnormal conditions are encoun-tered.Do not operate this product beyond the specified tem-perature, humidity or power source ratings.Use this product at temperature within –30 °C to +50 °C{22 °F to 122 °F}* and humidity below 90 %. The inputpower source is 12 V DC/24 V AC.* –10 °C to +50 °C {14 °F to 122 °F} at 12 V DCUse at low temperatures• To operate the camera at temperatures of –10 °C{14 °F} or lower, it will take 30 minutes or more afterturning on the power to warm up the camera.• Images may be disturbed because the built-in heater isautomatically toggled between ON and OFF resultingfrom a change in usage environment.What to do if OVER HEAT appears on the display.This message indicates that the inside of this product hasbecome extremely hot. Immediately turn off the productand contact your dealer.Smear Bright subjectBloomingDehumidifying device