405. Select →PUSH SW for SCALE and press SET.→ Zone scale adjustment becomes available.6. Adjust the zone scale using the [LEFT], [RIGHT], [UP], or [DOWN] button.7. To apply the settings, move the cursor to SET and press SET.→ The screen returns to the ZONE NUMBER selection menu.To delete the settings, select DEL and press SET.13. Electronic Zoom (EL-ZOOM)1. Move the cursor to EL-ZOOM.2. Select ON or OFF by pressing L or R.The factory default setting is OFF.ON: x2 electronic zoom is available with theZOOM switch on the controller.OFF: The electronic zoom function is dis-abled.3. While the cursor is on EL-ZOOM, press S.The EL-ZOOM setting menu appears.4. Move the cursor to PUSH SET for ZOOM andpress S to display the ZOOM setting menu.5. Press U or D to zoom in or out the image.6. Move the cursor to PUSH SET for PAN/TILTand press the [SET] button. The PAN/TILTsetting menu appears.7. Press [LEFT], [RIGHT], [UP], or [DOWN] but-ton to change the angular field of view.8. To return to the EL-ZOOM setting menu,press the [SET] button.14. Camera Picture Upside Down Positioning (UPSIDE-DOWN)1. Move the cursor to UPSIDE-DOWN.2. Select ON when you want to turn the picture upside down.15. Auto Image Stabilizer (STABILIZER)This function electronically compensates for an unstable camera image due to movement of amounting pole or bracket. The default setting is OFF.ON: Automatically compensates for an unstable image.OFF: Image stabilizer will not operate.Notes:• When set to ON, some effective pixels on the edge of the CCD are used by the stabilizationfunction. This may result in a small reduction in resolution and a narrower angle of view.After activating the image stabilizer function, check that the field of view is correct.** EL-ZOOM **PAN/TILT →PUSH SETZOOM →PUSH SETU TILT D/L PAN RRET END** EL-ZOOM **PAN/TILT →PUSH SETZOOM →PUSH SETU ZOOM DRET END