Panasonic WV-S4550LPJ User Manual

Also see for WV-S4550L: Important information Important information

20ESD MOUNT indicator⿟ When an SD memory card is inserted and could Lights off → Blinks green →be recognized Lights off⿟ When data can be saved after the SD memory card is Lights off → Lights greeninserted and the SD ON/OFF button is pressed(less than 1 second)⿟ When data can be saved to the SD memory card Lights green⿟ When the SD memory card is removed after holding down Lights green → Blinks green →the SD ON/OFF button (about 2 seconds) Lights off (recording)Lights green → Lights off(waiting for recording)⿟ When data cannot be saved to the SD memory card Lights offbecause an abnormality was detected or the SDmemory card is configured not to be usedGSD memory card warning/error indicator⿟ When a warning status is detected Lights red*SD memory card warning detection conditions: After the total use time has exceeded 6 yearsand the number of overwrite times has exceeded 2000.⿟ When an error status is detected Blinks red*SD memory card error detection conditions: Write error, read error, etc.Note:⿟ Lighting/blinking LED can be turned off with the software settings at any time. (The initial state islighting or blinking.) Set the LED to be solid off if necessary, depending on the installation condi-tions. (☞ Operating instructions included in the CD-ROM)⑴When the SD ON/OFF button is pressed (less than 1 second), the SD MOUNT indicator lightsup in green and data can be saved to the SD memory card.⑵ When the SD ON/OFF button is held down (about 2 seconds), the SD MOUNT indicator lightsoff and the SD memory card can be removed.FSD ON/OFF buttonDSD ERROR/ABF indicator X4571L X4571LM SD ERROR indicator S4550L S4550LM⿟ When ABF (Auto Back Focus) operation is being Blinks red (Interval of 1 time/ second)executed X4571L X4571LM⿟ When the set is being started Lights red⿟ When an SD memory card is recognized normally Lights red → Lights off⿟ When the SD card slot is not used or an abnormality is Lights red → Stays reddetected in SD card after the camera has startedNote:⿟ The default is off. According to the installation environment, set up with software as required.(☞ Operating instructions included in the CD-ROM)CLINK indicatorBACT indicator⿟ When the camera is able to communicate with Lights orangethe connected device⿟ When data is being sent via the network camera Blinks green (accessing)