13In order to prevent injury, the productmust be securely mounted to a wall orceiling according to Installation Guide.(Except for placing WV-S6130 upside-down)Power supplyThis product has no power switch.When performing electrical work, make sure thecamera can be turned on and off. When anEthernet cable or power cable is connected, thepower is turned on. When the power is sup-plied, the product will perform panning, tilting,zooming and focusing. When cleaning the prod-uct, remove the Ethernet cable or disconnectthe power cable from the main power supply.Installation area for this productSelect an appropriate place for the installationarea (such as a strong wall or ceiling) in yourparticular environment.• Make sure that the installation area isstrong enough to hold this product, suchas a concrete ceiling.• Install the camera in the foundation area ofthe architecture or where sufficient strengthis assured.• Do not mount the product on a plasterboard or a wooden section because theyare too weak. If the product is unavoidablymounted on such a section, the sectionshall be sufficiently reinforced.In addition to fitting the camera into a ceilingdirectly using the camera mount bracket(accessory), the camera can be installed usingthe special brackets as follows.S6131 S6111• When hanging the camera from a ceiling,use the WV-Q105A ceiling mount bracket(option) or the WV-Q126A ceiling embed-ding bracket (option).• When installing on a wall, use wall mountbracket WV-Q119 (option).S6130• When hanging the camera from a ceiling,use the WV-Q105A and WV-Q160C/WV-Q160S ceiling mount bracket (option)or the WV-Q159C/WV-Q159S ceilingembedding bracket (option).• When installing on a wall, use wall mountbracket WV-Q158C/WV-Q158S (option).This camera is designed to be used indoors.This product is not operable outdoors.Do not expose this camera to direct sunlightfor hours and do not install the product near aheater or an air conditioner. Otherwise, it maycause deformation, discoloration and malfunc-tion. Keep this camera away from water andmoisture.Do not place this product in the followingplaces:• Locations where a chemical agent is usedsuch as a swimming pool• Locations subject to moisture or oil smokesuch as a kitchen• Locations that have a specific environmentthat is subject to an inflammable atmo-sphere or solvents• Locations where a radiation, an X-ray, astrong radio wave or a strong magneticfield is generated• Locations near coasts directly subjected tosea breezes, or locations subject to corro-sive gases such as from hot springs, vol-canic regions, etc.• Locations where the temperature is notwithin the specified range (☞ page 30)• Locations subject to vibrations, such as onvehicles, marine vessels, or above productlines (This product is not designed for on-vehicle use.)• Locations where it may get wet from rain orwater splash (including under the eaves, etc.)Panasonic assumes no responsibility for injuries or property damage resulting from failuresarising out of improper installation or operation inconsistent with this documentation.For information about the installation tasks, refer to the provided Installation Guide.Precautions for installation