• Alarm output: Alarm output will be carried out according to the settings for “Alarm output terminalsetup” (®page 118).• Default: Off[Terminal 3]Determine how to use terminal 3.• Off: Not used.• Alarm input: Receives alarms. When “Alarm input” is selected, a pull-down menu for “Close” and“Open” is displayed.– Close: An alarm is detected when the terminal status is changed to “Close”.– Open: An alarm is detected when the terminal status is changed to “Open”.• AUX output: AUX output will be supplied. The [AUX] buttons will be displayed on the “Live” page.• Default: OffIMPORTANT• In order for the EXT I/O terminals to detect alarm inputs when the terminal status is changed from Opento Close (On) or from Close to Open (Off), about 100 ms or more is needed. Because alarms cannotbe detected for about 5 seconds after a detection is made, alarm inputs received within about 5 secondsafter an alarm is detected are not detected.Note• AUX is a camera terminal that allows users to operate (Open/Close) arbitrarily from the “Live” page.For example, an operator can remotely control lights in a place where the camera is installed byconnecting the terminal to the light controller.• Refer to the installation guide for further information about input/output rating of each terminal.[VMD alarm]When clicking “VMD >>”, the [VMD area] tab of the “Alarm” page will be displayed. (®page 127)[Audio detection alarm]When “Audio detection>>” is clicked, the [Audio detection] tab will be displayed. (®page 129)[Command alarm]Select “On” or “Off” to determine whether or not to receive the command alarm.The command alarm is the function that provides notification of a Panasonic protocol alarm from the othercameras. When “On” is selected, alarm actions will be performed between multiple cameras.• Default: Off[Originating port number]Select a port number to be used to receive the command alarm.• Available range: 1-65535• Default: 8181The following port numbers are unavailable since they are already in use.20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 554, 995, 10669, 10670, 59000-61000[Alarm deactivation time]Configure the duration that detections won't be made after an alarm is detected. For example, by using thisfunction you can prevent E-mail from being sent too often when E-mail notifications are configured to be sentto cellular phones when an alarm is detected.5s/ 10s/ 30s/ 1min/ 3min/ 5min/ 10minDefault: 5sOperating Instructions 11713 Configure the alarm settings [Alarm]
