[Open (Up to 5 characters)]Enter the name for “Open” of “AUX” on the “Live” page.• Unavailable characters: " &• Default: Open[Close (Up to 5 characters)]Enter the name for “Close” of “AUX” on the “Live” page.• Unavailable characters: " &• Default: CloseNote• AUX is a camera terminal that allows users to operate (Open/Close) arbitrarily from the “Live” page.For example, an operator can remotely control lights in a place where the camera is installed byconnecting the terminal to the light controller.13.6 Configure the VMD settings [VMD area]Click the [VMD area] tab on the “Alarm” page. (®page 47, page 49)The video motion detection areas can be set on this page.Up to 4 areas can be set. When motion is detected in the set area, it will be regarded as an alarm.IMPORTANT• The alarm occurrence indication button (®page 11) will be displayed when motion is detected by theVMD function.• The alarm occurrence indication button will be displayed when receiving an alarm input of a terminalalarm or a command alarm.• Depending on the network environment, notification may be delayed even when “Real time” is selectedfor “Alarm status update mode” on the [Basic] tab of the “Basic” page (®page 53).• After configuring the VMD area, the VMD area may move out of alignment when the JPEG/H.264“Image capture mode” setting is changed. Make sure to check the VMD area after changing the “Imagecapture mode” setting.• After configuring the VMD area, the VMD area may move out of alignment when “Extra opticalzoom” is configured. Make sure to check the VMD area after configuring “Extra optical zoom”.Operating Instructions 12113 Configure the alarm settings [Alarm]
