* If Patrol 2 is not registered it is not displayed on the screen.• Default: Off[Terminal alarm 3]Select an action to be taken when a terminal alarm 3 is detected from the following.• Off: Does not take any action even when a terminal alarm 3 is detected.• 1-256: If a previously registered preset position is selected, when a terminal alarm 3 is detected, the camerawill move to that position.• Auto track: When a terminal alarm 3 is detected, the camera will start the auto tracking.• Patrol 3: When a terminal alarm 3 is detected, the camera will start the patrol.* If Patrol 3 is not registered it is not displayed on the screen.• Default: Off[VMD alarm]Select an action to be taken when a VMD alarm is detected from the following.• Off: Does not take any action even when a VMD alarm is detected.• 1-256: If a previously registered preset position is selected, when a VMD alarm is detected, the camerawill move to that position.• Auto track: When a VMD alarm is detected, the camera will start the auto tracking.• Patrol 1: When a VMD alarm is detected, the camera will start the patrol.* If Patrol 1 is not registered it is not displayed on the screen.• Default: Off[Audio detection alarm]Select an action to be taken when a sound alarm is detected from the following.Off: Does not take any action even when a sound alarm is detected.1-256: If a previously registered preset position is selected, when a sound alarm is detected, the camera willmove to that position.Auto track: When a sound alarm is detected, the camera will start the auto tracking.Patrol 1: When a sound alarm is detected, the camera will start the patrol.* If Patrol 1 is not registered it is not displayed on the screen.Default: Off[Command alarm]Select an action to be taken when a command alarm is detected from the following.• Off: Does not take any action even when a command alarm is detected.• 1-256: If a previously registered preset position is selected, when a command alarm is detected, the camerawill move to that position.• Auto track: When a command alarm is detected, the camera will start the auto tracking.• Patrol 1: When a command alarm is detected, the camera will start the patrol.* If Patrol 1 is not registered it is not displayed on the screen.• Preset per sender: By registering the sender's address for the command alarm and the preset positionfor that address, the camera will move to the preset position when an alarm is detected from the commandalarm.Click “Preset per sender >>” to open a separate window for setting preset positions for alarms.(®page 138)• Default: Off13.2.1 Configure the settings relating to Preset per sender (“Presetper sender” setup menu)On the [Alarm] tab of the “Alarm” page (®page 137), click “Preset per sender >>” for “Command alarm”.138 Operating Instructions13 Configure the alarm settings [Alarm]
