Panasonic WV-X8570N Important Information Manual

Contents

17■ CablesARJ45 NetworkcableEthernet cable (category 5eor better, straight)B4P alarm cable (accessory)BAlarm I/O cableCAudio input cable (white)ARJ45 Network cableConnect an Ethernet cable (category 5e or better, straight) to the RJ45 Network cable.IMPORTANT:⿟ Use all 4 pairs (8 pins) of the Ethernet cable.⿟ The maximum cable length is 100 m {328 feet}.⿟ Make sure that the PoE device in use is compliant with IEEE802.3af standard.⿟ When the Ethernet cable is disconnected once, reconnect the cable after around 2 seconds.When the cable is quickly reconnected, the power may not be supplied from the PoE device.* This illustration represents WV-X8570NThis cable isprovided only withWV-X8570N.DUSB terminal(for installationconstructor)BAlarm I/O cable / 4P alarm cable (accessory) X 8570Note:⿟ Off, input, and output of the external I/O terminal 2 and 3 can be switched by configuring thesetting. Refer to the Operating Instructions on the Panasonic support web site for further infor-mation about the external I/O terminal 2 and 3 (ALARM IN2, 3) settings ("Off", "Alarm input","Alarm output" or "AUX output").Connect the 4P alarm cable (accessory) to the alarm I/O cable, and connect the external devicecable to the 4P alarm cable.⿟ ALARM IN1 (Black & white input / Auto time adjustment input), ALARM IN2, ALARM IN3Input specification : No-voltage make contact input (4 V - 5 V DC, internally pulled up)OFF : Open or 4 V - 5 V DCON : Make contact with GND (required drive current: 1 mA or more)⿟ ALARM OUT, AUX OUTOutput specification : Open collector output (maximum applied voltage: 20 V DC)ON : 4 V - 5 V DC by internal pull-upOFF : Output voltage 1 V DC or less (maximum drive current: 50 mA)