25Note:For more information on the following content, refer to the Operating Instructions. Please set [Time & date] on the [Basic] screen of “Setup” before using the camera. It is impossible to display H.265 (or H.264) or MJPEG images, receive audio X 8570 ,display logs, and use full-screen display when the viewer software “NetworkCamera View 4S” is not installed on the PC. Depending on the environment of your PC, it may take time for images to be displayed. At the time of purchase, the audio input are set to “Off”.If needed, change the setting onthe “Audio” screen in “Setup”. Due to security enhancements in “IP Setting Software”, “Network settings” cannot bechanged when around 20 minutes have passed after turning on the power of thecamera to be configured. (When the effective period is set to “20 min” in the “Easy IPSetup accommodate period”.) However, settings can be changed after 20 minutes forcameras in the initial set mode.If images are not displayed, set the Web browser to compatibility view. For details on how toconfigure, refer to our website (https://security.panasonic.com/support/info/)【4】When the administrator registration window is displayed, enter “Username”,“Password” and “Retype password” by following the instructions displayed onthe screen, and then click the [Set] button.IMPORTANT: When the camera is used over the Internet, setting user authentication to “Off” maylead to unintended access by a third party. Please leave user authentication set to“On”.【5】When live images from the camera are displayed, the network connection is complete.Please keep your user name and password in a safe place free from public view to ensuresecurity. After completing the registration, the camera will automatically be re-connected andthe authentication window will be displayed. Enter the registered user name and password.The default setting of user authentication is “On”. For further information, refer to the “Preface”section in the Operating Instructions on the Panasonic support web site.X 8570