PAN1322Application Note 51 Revision 1.2, 2013-12-18Design Guide9 Test and Development ToolsThis chapter is aimed to clarify some common issues from the customers.9.1 Tools available for development and testing9.1.1 SPP ToolboxThe SPP Toolbox is used to control eUniStone with AT commands, to setup links and as described inlater chapter, to do RF tests. A detailed manual is delivered with the Toolbox.For testing of the PBA31309 with SPP AT SW 3.x the SPP Toolbox shall have version number 3.02 orlater.9.1.2 SPP Test ToolThe SPP Test Tool is used for throughput tests, both in command mode and stream. For more detailsabout this tool, please see the manual delivered with the tool.For testing of the PBA31309 with SPP AT SW 3.x the SPP Test Tool shall have version number 2.1.1.0 orlater.9.1.3 HCI LiteHCI Lite is used together with eUniStone when it has been loaded with Host Controller Interfacesoftware (HCI_TL_ROM_115kbaud.eep). The purpose of the tool is to use it for advanced RF tests. Arange of HCI commands is implemented in the tool to be able to set-up eUniStone in different RFmodes.For testing of the PBA31309 with SPP AT SW 3.x the HCI Lite should have version number 3.03 or later.Attention: After loading Host Controller Interface software (HCI_TL_ROM_115kbaud.eep), thedevice can only revert to the original SW by the use of an I2C programmer!9.1.4 eeprog – AardvarkThe eeprog.exe software is used together with the Aardvark I2C/SPI Host Adapter to downloadsoftware to eUniStone through the I2C interface.The Aardvark I2C/SPI Host Adapter is a hardware dongle available through Total Phase. The eeprog.exeis only available in one version and is not dependent on SPP AT SW version.
