Panasonic eUniStone Application Note Design Manual

Contents

Panasonic eUniStone Application Note Design Manual Manual pdf 62 page image

 PAN1322Application Note 62 Revision 1.2, 2013-12-18Design GuideFigure 26. Crystal Trimming using HCI Lite ToolThe crystal trimming procedure using a frequency counter and the HCI Lite tool is as following:1. Make the 32 MHz clock available at P0.1 or P0.8 using the HCI_Lite tool. (See inFigure 26)a. Select P0.1 or P0.8 pin for output of the 32 MHz clockb. Click “Open port for 32 MHz”2. Connect the frequency counter to the appropriate test pin P0.1 or P0.8.3. The 32 MHz clock signal can now be measured by the frequency counter.4. Write the trimming value to the Osc_Trim register through the HCI Lite tool. Thestart value is 0x19F. (See in Figure 26)a. Enter the Osc_Trim value in the text box for Osc_Trimb. Click “Write Osc_Trim”164