Paradyne ACCULINK 336x E1 Operator's Manual

Also see for ACCULINK 3360: Quick installation Operator's guide User guide

Contents

Paradyne ACCULINK 336x E1 Operator's Manual Manual pdf 49 page image

ACCULINK 336x E1 NTU3-28 December 1996 3360-A2-GB20-208. If you selected NET the channels allocated to thenetwork interface are displayed. Line 1 displaysthe 31 channels for the network interface, whileLine 2 displays what is allocated to the DS0channel shown in Line 1. Pressing the orkey scrolls the channels onto the screen in groupsof three.F1N1 N2 N3D2 D3 Prt1F2 F3If you selected DTE, the channels allocated to theG.703 DTE interface are displayed. Line 1displays the 31 channels for the G.703 DTEinterface, while Line 2 displays what is allocatedto the DS0 channel shown in Line 1.F1D1 D2 D3– N1 N2F2 F3Allocating Data PortsBy using the configuration options, assign a specificport to DS0 channels on either the network interface orthe G.703 DTE interface. The following methods areavailable to assign DS0 channels to the port:Block – Allows a block of contiguous channels to beassigned by specifying a data port rate and an initial DS0channel (the first DS0 channel in a block of DS0channels). The number of channels assigned is determinedby the port rate. Only those initial DS0 channel numbersthat provide enough bandwidth (based on the port’s datarate) are displayed on the screen. These channels areautomatically assigned to the destination E1 interface(HDSL or G.703 DTE) when the initial DS0 channel isselected.Chan – Individually selects the DS0 channels toallocate to the data port. The data port rate isautomatically determined based on the number ofchannels selected.Once a port is selected, you have access to theconfiguration options to complete the port allocationprocedure. These configuration options enable you to,• Assign the selected port to the desired interface• Select the desired method for channel allocation• Select the port rate and starting channel (if theallocation method is block)• Select the specific channels (if the allocationmethod is by individual channel)These configuration options are explained in detail inAppendix C.To select the data port,1. From the top-level menu screen, select Cnfig.2. Select the configuration option set to be copiedinto the Edit area by using the appropriateFunction key. Use the scroll keys, if necessary.3. Select Edit.4. From the Edit screen, press the key until theChan selection appears on the screen.5. Select Chan.F1Edit:DTEPort NET ChanF2 F36. From the Channel Config screen, press thekey to scroll the ports onto the screen.F1Channel Config:Dsply Clear DTEF2 F3