Paradyne COMSPHERE 6800 Series Multiplexer Management And Configuration Manual

Also see for COMSPHERE 6800 Series: Release note Release note Release note Installation and Enabling/Disabling Instructions Communications Products Support Configuration Guide

Contents

Paradyne COMSPHERE 6800 Series Multiplexer Management And Configuration Manual Manual pdf 66 page image

Managing Multiplexers1-556800-A2-GB21-10 August 1994Figure 1-6. Destination Node(s) Window2. Click on the node to be inserted.If an error window appears indicating that all nodes are present in the routing table, checkthat the device and facility profiles are properly entered. These profiles must be presentbefore the node can be inserted in the routing table.3. Click on the OK button.An entry for the selected destination node is inserted into the routing table in its propersequence. The I-bar appears in the link list area for the entry of the links associated withthis destination node.4. TYPE: the links associated with the new destination node (separate multiple links bycommas.)PRESS: EnterAn “*” appears in the ♦ column indicating that this destination node has been modified.To insert a new link identifier in the link list for an existing destination node, perform thefollowing steps:1. Click on the point in the link list where you want to insert the new link identifier.The I-bar appears at that point.2. TYPE: the new link identifier (separate multiple links by commas.)PRESS: EnterAn “*” appears in the ♦ column indicating that this destination node has been modified.