Important InformationB7924-A2-GB20-20 August 1997Important Safety Instructions1. Read and follow all warning notices and instructions marked on the product or included in the manual.2. Do not allow anything to rest on the power cord and do not locate the product where persons will walk on thepower cord.3. Do not attempt to service this product yourself, as opening or removing covers may expose you to dangeroushigh voltage points or other risks. Refer all servicing to qualified service personnel.4. General purpose cables are provided with this product. Special cables, which may be required by the regulatoryinspection authority for the installation site, are the responsibility of the customer.5. When installed in the final configuration, the product must comply with the applicable Safety Standards andregulatory requirements of the country in which it is installed. If necessary, consult with the appropriate regulatoryagencies and inspection authorities to ensure compliance.6. A rare phenomenon can create a voltage potential between the earth grounds of two or more buildings. Ifproducts installed in separate buildings are interconnected, the voltage potential may cause a hazardouscondition. Consult a qualified electrical consultant to determine whether or not this phenomenon exists and, ifnecessary, implement corrective action prior to interconnecting the products.7. In addition, if the equipment is to be used with telecommunications circuits, take the following precautions:— Never install telephone wiring during a lightning storm.— Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.— Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at thenetwork interface.— Use caution when installing or modifying telephone lines.— Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk ofelectric shock from lightning.— Do not use the telephone to report a gas leak in the vicinity of the leak.