Paradyne HotWire 7974 User Manual

Also see for 7984: Installation instructions User guide Installation instructions

Contents

Paradyne HotWire 7974 User Manual Manual pdf 92 page image

Messages and Troubleshooting7-2 7970-A2-GB20-00August 1999Configuring SNMP TrapsAn SNMP trap can be automatically sent out through the EOC or theManagement port to an SNMP manager when the Hotwire 79xx StandaloneTermination Unit detects conditions set by the user. These traps enable theSNMP manager to gauge the state of the network. Refer to Appendix B,Standards Compliance for SNMP Traps, for details of SNMP traps supported bythe unit.Use the SNMP Traps Options screen to: Enable SNMP traps. Set the number of SNMP managers that receive SNMP traps from the unit byentering an IP address and network destination for each SNMP managerspecified. Select the type of SNMP traps to be sent from the unit.To configure SNMP Traps, follow this menu selection sequence:Main Menu →Configuration →Load Configuration From →Management and Communication Options →SNMP Traps OptionsÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎÎmain/config/management/trap HotwireModel: 79xxSNMP TRAPS OPTIONSSNMP Traps: Enable Number of Trap Managers: 5NMS 1 IP Address: 135.014.040.001 Clear Destination: DSLNMS 2 IP Address: 135.014.003.027 Clear Destination: DSLNMS 3 IP Address: 135.014.001.008 Clear Destination: DSLNMS 4 IP Address: 135.014.002.024 Clear Destination: DSLNMS 5 IP Address: 204.128.146.035 Clear Destination: DSLGeneral Traps: BothEnterprise Specific Traps: EnableLink Traps: BothLink Traps Interfaces: Network–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––Ctrl-a to access these functions, ESC for previous menu MainMenu ExitSaveSome fields are not displayed if the unit is connected to a DSLAM card running inIP Conservative mode. Refer to Table A-11, SNMP Traps Options, to configureSNMP traps.