Parker LCB Series Mounting Instructions

Also see for LCB Series: Installation, Commissioning, Maintenance and Repair

Contents

Parker LCB Series Mounting Instructions Manual pdf 11 page image

Parker EME Commissioning192-510014 N06 April 2013 11In this chapter you can read about:Preparations for substructure........................................................................................... 11Fitting / mounting ............................................................................................................. 12The linear module is furnished completely mounted and mechanically ready-to-operate.If no Parker drive is provided, attach your motor-gearbox combination according tothe instructions of the respective supplier.The technical data must be respected.Technical data: See in the catalog section (following the mounting instructions).2.1 Preparations for substructureEach holding point must be even with a flat parallelism of 0.2 mm. All holding points must be alignedwith parallelism to each other of better than 0.5 mm.To simplify installation and adjustment, the holding points for the linear actuator can also consist ofadapter plates. They can be aligned with tightening and pressure screws.Deflection vs. distance between mountings and payloadLCB040(1): Maximum permitted deflectionFn FnSA SA SA(1)0 500 1000 1500 2000 2500 3000Stützabstand SA [mm]Kraft Fn / N0,11,010000,010,0100,01000,00,1 mm0,2 mm0,3 mm0,5 mm1,0 mmDistance between mountings SA [mm]Force Fn / N0.11.010000.010.0100.01000.00.1 mm0.2 mm0.3 mm0.5 mm1.0 mm2. Commissioning