Parker MA3 Series User Manual

Also see for MA3 Series: Maintenance Bulletin

Page 54When either or both Cleared (= 0) is the same as:DRIVE ENABLE = FALSEEnable Ramp Output, Enable Ramp, Enable Ramp InputNot implemented. The state of these bits must be set (=1) to allow this feature to be added in thefuture.Reset FaultReplaces the REM TRIP RESET parameter on the SEQUENCING LOCIC function block.When Set (=1) is the same as:REM TRIP RESET = TRUEWhen Cleared (= 0) is the same as:REM TRIP RESET = FALSERemoteNot implemented. It is intended to allow the PLC to toggle between local and remote. The stateof this must be set (=1) to allow this feature to be added in the future.Communications StatusThe COMMS STATUS parameter (PREF 95.08) in the COMMS CONTROL function blockmonitors the sequencing of the Inverter. It is a 16-bit word based on standard fieldbus inverterprofiles. Some bits are not implemented in the initial release and are set to 0 (see “Supported”column of the table below).