Parker OSPP-Classic Operating Instructions Manual

16Pneumatic Linear Drive OSPP-Classic / KF11.2 CleaningGeneralFor cleaning, use only material-protective media and non-fluffy cloths.Do not use high-pressure cleaners!11.3 Cylinder Removal, Dismantling and CleaningDanger of eye injuries and cuts on fingers etc.Safety glasses must be worn!There is danger of :• Eye injuries from flying dirt particles and stressed springs - wear safety glasses where indicated!• Cuts from sharp edges of inner sealing band.• Wear protective gloves when working with inner sealing band.Procedure:• Depressurise cylinder/plant.• Disconnect load.11.3.1 Dismantling of cylinderInformation• Please observe the position of the parts on the exploded view drawing on page 28.Remove cover• Remove screws (36) and end caps (35) and remove end caps (35) on both sides.Dismantle sealing bands and piston• Only for Ø 16 to 50 : remove carrier clamping screws (38) and dismantle wiper O-ring (7)and carrier (10).• Only for Ø 63 and 80: remove all screws (5),pull off cover (9) with wipers (8), springs (6) and O-rings (7) and dismantle.• Pull off two clamp covers (12).• Remove 2 screws (13) and (15) each for the outer and inner band clamping.• Remove two clamping pieces (14) for outer sealing band.• Remove outer sealing band (11).• Remove two clamping pieces (16) for inner sealing band.• Pull off two cushioning spigots (20) by inserting screwdriver carefully between cushioningspigot (20) and cylinder barrel (1).• Push piston and inner sealing band (17) out of cylinder bore (1).• Pull inner sealing band (17) out of piston.Remove piston• Remove two support rings (25) and remove spacers (29) with magnet (30).• Remove slide shoe (28) and for Ø 63 and 80 side wiper (31).• Remove piston seal (24) and cushioning seal (23).Cleaning and spare part check• Clean all parts and replace damaged or worn parts.Use original spare parts only. We recommend to use the spare parts listed on page 28.• Re-assembly must be carried out on a clean surface.