INSTALLATION20 Parker Automation Controller Installation GuideChecking Your ShipmentUse the following steps to check your PAC shipment. Note that PACIO Modules may be shipped inpackaging that is separate from the PAC Controller.Remove all items from the packaging.Confirm that you have received each item listed in the table below.Technical Assistance fromParker Hannifin in the Troubleshooting chapter of this guide.PAC Ship KitPart Name Part NumberParker Automation Controller PAC320-xxxxx-xxSD Card 33-026611-01DC Power Input Connector,3-Pin with tension-clamp wire terminals 43-026582-01 (inserted in the PAC)Parker Software License Agreement A4-04291-102Getting Started Sheet 88-032477-01Required ToolsInstalling the PAC and PACIO Modules on the DIN rail requires no tools. However, a small flat bladescrewdriver (tip size 0.04mm x 2.5mm) is required for attaching the wiring to the PAC Controller andPACIO Modules.Installation Safety RequirementsThe PAC meets the requirements of the European Low Voltage Directive (LVD) 2006/95/EC and theElectromagnetic Compliance (EMC) directive 2004/108/EC, and Safety Requirements EN61010 wheninstalled according to the instructions provided in this chapter.WARNING: To avoid injury or electrical shock, always remove power to thePAC before connecting electrical devices (for example, PACIOModules).WARNING: The PAC connects to other mechanical and electrical componentsof your system. Be sure to test your system for safety under allpotential conditions. Failure to do so may result in seriouspersonal injury or damage to equipment.
