4 • Alarms '6/'$&6$GPLQLVWUDWRUVª5HIHUHQ H*XLGH32 'LVSOD\LQJWKHDODUPVZLQGRZAlarm Response OutputsAlarm Response Outputs display the current setting for handling alarm notification via the different AlarmResponse Outputs. To change the Alarm Response Outputs parameters, refer to “Alarm Parameters” onpage 33.5HOD\ 5HVSRQVHThe relay of the Alarm Port on the rear of the chassis will be activated when a major, minor, or both major andminor alarm is generated. The Alarm Port may also be disabled.0LQRU $ODUP 6<6/2* 3ULRULW\ PLQ6\VORJ3ULRULW\ Sets the priority of the minor alarm SYSLOG message that will be generated upon the occurrence of a minoralarm.0DMRU $ODUP 6<6/2* 3ULRULW\ PDMRU6\VORJ3ULRULW\ Sets the priority of the major alarm SYSLOG message that will be generated upon the occurrence of a majoralarm.0LQRU $ODUP 6103 7UDS ,3 >DGGUHVV@ PLQRU7UDS,S Displays the IP address of a SNMP management station for receiving the SNMP trap messages upon theoccurrence of an active minor alarm. The SNMP trap messages are sent in UDP datagrams. When the IPaddress is set to 0.0.0.0, no trap messages will ever be sent.0DMRU $ODUP 6103 7UDS ,3 >DGGUHVV@ PDMRU7UDS,S The same function as the Minor Alarm Trap IP except for only the occurrence of active major alarms.7HPSHUDWXUH 7KUHVKROGAn alarm will be generated when the box temperature exceeds this temperature value in degrees Celsius.&XUUHQW %R[ 7HPSHUDWXUHThe internal temperature in the box in degrees Celsius.&OHDU $OO $ODUPVClick on this button to clear all the alarms (that is, to reset all the alarms). This clearing action will, for all thealarms, reset the alarm, reset Time Since Alarm to 0.00 seconds, and reset the Alarm Count to 0 (zero).AlarmsThis portion of the Alarms main window displays the alarm status table, where you can view current alarm sta-tus, manually generate an alarm as a test, and clear the alarm time and alarm count variables.$ODUP ,'This number identifies the alarm item.$ODUP 1DPHThe alarm items are grouped into two categories: system and WAN trunk alarms. The system group categorylists DACS temperature and power supply status. The WAN category monitors the T1/E1/PRI ports for yel-low and red alarms.
