Patton electronics IPLink 2635 Getting Started Manual

Also see for Patton IPLink 2603: Specification sheet Quick start guide Specification sheet Getting started guide

Contents

Introduction 130Models 2603, 2621, and 2635 Getting Started Guide E • Command Line Interface (CLI) OperationIntroductionThe modem configuration and status can also be view and modified through the console, which is accessiblethrough the RS-232 serial port or through a Telnet session over Ethernet.CLI TerminologyIn order to use the CLI commands, you need to understand the following CLI terms:• Transport: A transport is a layer 2 session and everything below it. You can create a transport and attach it toa bridge or router so that data can be bridged or routed via the attached transport. The CLI supports thefollowing transports:• PPPoE: Point-to-Point Protocol over Ethernet• Frame Relay• PPP: Point-to-Point Protocol over HDLC• Ethernet• Interface: bridges and routers both have interfaces. A single transport is attached to a bridge or router via aninterface.• Object: an object is anything that you can create and manipulate as a single entity, for example, interfaces,transports, static routes and NAT rules.• List: Objects are numbered entries in a list. For example, if you have created more than one ethernet trans-port, the following command:ethernet list transportsproduces a list of numbered transport objects:ID Name Port1 eth2 ethernet2 eth1 ethernetLocal (VT-100 emulation)A connection is made with the DB9-RJ45 adapter and an RJ45-RJ45 straight-through cable. Set the data rateto 9,600 baud, 8 data bits, one stop bits, and no parity. You may use a dumb terminal or a VT-100 emulationsuch as HyperTerminal.Remote (Telnet)Establishing a Telnet session displays the same CLI configuration and status parameters on the display.Using the ConsoleThe console commands needed for the various modes of operation are described in later sections. In this sub-section are the most basic commands needed for console operation.By entering “?” all the high level commands (the keywords) are seen.

/ 133

Related manuals for Patton electronics Patton IPLink 2603