Patton electronics IPLink 2635 Getting Started Manual

Also see for Patton IPLink 2603: Specification sheet Quick start guide Specification sheet Getting started guide

Contents

Hardware installation 37Models 2603, 2621, and 2635 Getting Started Guide 3 • Initial Configuration7. A message will display, “Login Successful.” By typing the character “?”, all the commands will be displayed.Login: superuserPassword: *********Login successful-->8. Any commands’ parameters may be seen by entering the command followed by a space and a questionmark.→ ethernet ? [The following parameters appear]adddeletesetshowlistclearIP address modificationThe first parameter to change is the IP address from the default IP address of 192.168.200.10 to your selectedIP address. Do the following (comments are in brackets […]):→ ip list interfaces [lists the characteristics of the different interfaces]IP Interfaces:ID | Name | IP Address | DHCP | Transport-------|---------------|------------------|-------------|------------------1 | ip1 | 192.168.200.10 | disabled | eth0---------------------------------------------------------------------------→ ip set interface ip1 ipaddress 10.10.19.10 255.255.0.0 [Sets the new IP address which you have selected. The IPaddress in this example is for illustrative purposes only.]→ ip list interfaces [To see if the change in IP address is correct]→ system config save [To save the new IP address in flash memory.]→The IP address has now been successfully changed.Web Operation and ConfigurationNow that the IP address has been configured for your application, you can complete the configuration usingany standard web browser.PC ConfigurationIn order to connect the PC to the Ethernet LAN to communicate with The IPLink Series router, the PC’s IPaddress should be on the same subnet as the router.Connect a straight-through Ethernet cable between the PC’s NIC or PCMCIA Ethernet card and an Ethernethub or switch.Web BrowserDo the following:1. Launch a standard web browser such as Netscape Communicator or Internet Explorer (IE).