Philips 1200 Series User Manual

Also see for 1200 Series: User manual User manual User manual User manual User manual

Cleaning LatteGo (milk container)Cleaning LatteGo after every use1 Remove LatteGo from the machine (Fig. 34).2 Pour out any remaining milk.3 Press the release button and remove the milk container from the frame of LatteGo (Fig. 35).4 Clean all parts in the dishwasher or under the tap with lukewarm water and some washing-upliquid.Cleaning the classic milk frotherCleaning the classic milk frother after every useClean the milk frother each time you use it for hygiene reasons and to avoid the build-up of milkresidues.1 Place a cup under the milk frother.2 Tap the steam icon and then press the start/stop button to start dispensing steam and toremove any milk that may be left inside the milk frother.3 To stop dispensing steam after a few seconds, press the start/stop button again.4 Clean the milk frother with a damp cloth.Daily cleaning of the classic milk frother1 Let the milk frother cool down completely.2 Tilt the milk frother to the left (Fig. 36) and remove both the metal part and the silicone part (Fig.37).3 Disassemble the two parts (Fig. 38) and rinse them with fresh water or clean them in thedishwasher. Make sure that the small hole on the metal tube is completely clean and not cloggedby milk residues.4 Reassemble the two milk frother parts and reattach the milk frother to the machine.AquaClean water filterYour machine is AquaClean enabled. You can place the AquaClean water filter in the water tank topreserve the taste of your coffee. It also diminishes the need for descaling by reducing limescalebuild-up in your machine. You can purchase an AquaClean water filter from your local retailer, fromauthorized service centers or online at www.philips.com/parts-and-accessories.AquaClean icon and lightYour machine is equipped with an AquaClean water filter light (Fig. 39) to indicate the status of thefilter. Use the table below to see what actions are required when the light is on or when it is flashing.When you use the machine for the first time, the AquaClean light starts flashingorange. This indicates that you can start using the AquaClean water filter. If you donot activate an AquaClean water filter, the light will switch off automatically after awhile.Once you have installed the filter and activated it with the AquaClean icon, theAquaClean light turns blue to confirm that the AquaClean water filter is active.When the filter is exhausted, the AquaClean light starts flashing orange again toremind you to replace the filter with a new one.15English