Philips 55PUG6801 User Manual

Also see for 6801 SERIES: Quick start guide User manual User manual User manual User manual

ProblemsWireless network not found or distorted• Microwave ovens, DECT phones or other Wi-Fi802.11b/g/n devices in your proximity might disturbthe wireless network.• Make sure that the firewalls in your network allowaccess to the TV's wireless connection.• If the wireless network does not work properly inyour home, try the wired network installation.Internet does not work• If the connection to the router is OK, check therouter connection to the Internet.The PC and Internet connection are slow• Look in your wireless router's user manual forinformation on indoor range, transfer rate and otherfactors of signal quality.• Use a high-speed (broadband) Internet connectionfor your router.DHCP• If the connection fails, you can check the DHCP(Dynamic Host Configuration Protocol) setting of therouter. DHCP should be switched on.Wired ConnectionWhat You NeedTo connect the TV to the Internet, you need anetwork router with a connection to theInternet. Use a high-speed (broadband) connectionto the Internet.Make the ConnectionTo make a wired connection…1 - Connect the router to the TV with a network cable(Ethernet cable**).2 - Make sure that the router is turned on.3 - Press , select All Settings and press OK.4 - Select Wireless and Networks andpress  (right) to enter the menu.5 - Select Wired or Wi-Fi > Connect toNetwork and press OK.6 - Select Wired and press OK. The TV constantlysearches for the network connection.7 - A message will be shown when the connection issuccessful.If the connection fails, you can check the DHCPsetting of the router. DHCP should be switched on.**To fulfill EMC regulations, use a shielded FTP Cat.5E Ethernet cable.Network settingsView Network SettingsYou can view all current network settings here. TheIP and MAC address, signal strength, speed,encryption method, etc.To view the current network settings…1 - Press , select All Settings and press OK.2 - Select Wireless and Networks andpress  (right) to enter the menu.3 - Select Wired or Wi-Fi > View NetworkSettings and press OK.4 - Press  (left) repeatedly if necessary, to closethe menu.Network ConfigurationIf you are an advanced user and want to install yournetwork with Static IP addressing, set the TV to StaticIP.To set the TV to Static IP…1 - Press , select All Settings and press OK.2 - Select Wireless and Networks andpress  (right) to enter the menu.3 - Select Wired or Wi-Fi > NetworkConfiguration and press OK.4 - Select Static IP and press OK to enable StaticIP Configuration.5 - Select Static IP Configuration and configure theconnection.6 - You can set the number for the IPAddress, Netmask, Gateway, DNS 1, or DNS 2.7 - Press  (left) repeatedly if necessary, to closethe menu.Switch On with Wi-Fi (WoWLAN)You can switch this TV on from your smartphone ortablet if the TV is on Standby. The setting Switch Onwith Wi-Fi (WoWLAN) must be switched on.To switch on WoWLAN…1 - Press , select All Settings and press OK.2 - Select Wireless and Networks andpress  (right) to enter the menu.3 - Select Wired or Wi-Fi > Switch On with Wi-Fi9