4 Disassemble all parts (Fig. 32) and clean them under the tap.5 Reassemble the internal cappuccinatore.6 To place back the internal cappuccinatore, put it in upright position and make sure the holes arealigned with the two tubes on the machine. Then move the internal cappuccinatore upwards until itlocks into place (Fig. 33).7 Close the door.Visit www.saeco.com/care for detailed video instructions.Descaling procedurePlease use Philips descaler only. Under no circumstances should you use a descaler based on sulfuricacid, hydrochloric acid, sulfamic or acetic acid (vinegar) as this may damage the water circuit in yourmachine and not dissolve the limescale properly. Not using the Philips descaler will void yourwarranty. Failure to descale the appliance will also void your warranty. You can buy Philips descalingsolution in the online shop at www.saeco.com/care.1 When the machine asks you to descale it, press the start/stop button to start. To start descalingwithout being prompted by the machine, tap the Clean icon and select 'Descale' (Fig. 34).2 Remove the drip tray and the coffee grounds container, empty them and put them back into place.3 Remove the water tank and empty it. Then remove the AquaClean filter.4 Pour the whole bottle of Philips descaler in the water tank and then fill it with water up to the CALCCLEAN level. Then place it back into the machine.5 Place a large container (1.5 l) under the coffee dispensing spout.6 Follow the instructions on the screen to start the descaling procedure. The descaling procedurelasts approx. 15 minutes and consists of a descaling cycle and a rinsing cycle.7 Once the descaling cycle is finished, you need to rinse the water tank and water circuit. Follow theinstructions on the screen.8 Place a new AquaClean filter in the water tank and reactivate the AquaClean filter in the menu.Tip: Using the AquaClean filter reduces the need for descaling!What to do if the descaling procedure is interruptedYou can exit the descaling procedure by pressing the on/off button on the control panel. If thedescaling procedure is interrupted before it is completely finished, do the following:1 Empty and rinse the water tank thoroughly.2 Fill the water tank with fresh water up to the CALC CLEAN level indication and switch the machineback on. The machine will heat up and perform an automatic rinsing cycle.3 Before brewing any drinks, perform a manual rinsing cycle. To perform a manual rinsing cycle, firstdispense half a water tank of hot water and then brew 2 cups of pre-ground coffee without addingground coffee.Note: If the descaling procedure was not completed, the machine will require another descalingprocedure as soon as possible.15EnglishEnglish