QCT QuantaMesh Installation Manual

Contents

QCT QuantaMesh Installation Manual Manual pdf 25 page image

Network Switch lnstallation Guide 25QuantaMesh T3000 SeriesBase-T Port ConnectionThe switch is a new generation 10GBASE-T solution for data center networking which provides 48triple speed (100/1000/10 GBase-T) ports.The Base-T ports are numbered and have corresponding Base-T port LEDs.To connect to the Base-T port, do the following:1 Connect one end of an Ethernet cable to the Base-T port.333435363738394041424344454647482 Connect the other end of the Ethernet cable to a network.The Base-T port LED (Link/Activity LED) lights green when the network link is established.QSFP+ Port Connection (MPO Type Connector)The switch is equipped with 6 QSFP+ (Quad SFP) ports. There are two types of QSFP+ ports:• There are four 40G QSFP+ ports on the front panel which support 40G/per port or fan outto 4x10G by using the fan out DAC cable described in the “40-Gigabit ports” section on page24.• The QSFP+ port on the rear panel provides only one channel of data in one pluggableinterface.The QSFP+ ports are numbered and have corresponding QSFP+ port LEDs.To install a QSFP+ module, do the following:1 Slide the QSFP+ module into a QSFP+ port.2 Push completely until the module locks into place.2434445464748 PSU1 PSU2FAN49575051525853 5459 6055 5665 6661 6267 6863 64ACDC7069Front panel Rear panel3 Repeat the above procedures to install additional QSFP+ modules.The QSFP+ port LED lights green when the network link is established.