QCT QuantaMesh Installation Manual

Contents

QCT QuantaMesh Installation Manual Manual pdf 37 page image

Network Switch lnstallation Guide 37QuantaMesh T5000 SeriesPower Supply of T5032-LY6Equipped with two supply modules, the switch can operate with either one or two power supplymodules. If the switch uses two power supply modules, you can hot-swap one of the PSU duringthe operations.NOTE:• Only one PSU is required to operate a fully loaded chassis.There are two types of PSU. Each plug retainer is color-coded to indicate its airflow direction.• Red: indicates front-to-back airflow.• Blue: indicates back-to-front airflow.PSU LEDPSU handlePlug retainerThe AC power connector is a standard three-pronged connector. The switch automatically adjustsits power setting to any supply voltage in the range from 100~240 VAC at 50~60 Hz.NOTE:• Verify that each module has the same airflow direction. Make sure the switch runs with all of itspower supply and fan tray modules taking in air from a cold aisle and exhausting air to the hotaisle.About the AC Power Connector ConnectionThis switch has 2 AC power connectors on the front and rear panels. The power supplyconnection varies depending on the operating scenarios:• If you are using the AC power connectors on the front panel for the power supply, make sureboth power cords at the rear panel are properly connected. Then plug the power cables intothe respective AC power connectors on the front panel.• If you ONLY use the AC power connectors on the rear panel for the power supply, you havethe unplug the power cords located at the rear panel first. Then plug the power cords into therespective AC power adapters, and plug the AC power adapters to a wall outlet.Power cordRear panelFront panelPower cord