282.5 Connecting to NAS by Web BrowserTo connect to the NAS by a web browser, follow the steps below:1. Enter http://NAS IP:8080 in the web browser. Or, use the QNAP Qfinder to find theNAS, double click the NAS name, and the NAS login page will open.Note : The default NAS IP is 169.254.100.100:8080. If the NAS has been configuredto use DHCP, you can use the QNAP Qfinder to check the IP address of the NAS.Make sure the NAS and the computer that runs the QNAP Qfinder are connected tothe same subnet. If the NAS cannot be found, connect the NAS to the computerdirectly and run the QNAP Qfinder again.2. Enter the administrator name and password. Turn on the option "Securelogin" (Secure Sockets Layer login) to allow secure connection to the NAS. If a userwithout administration right login the NAS, the user can only change the loginpassword (default administrator name: admin; default password: admin).Note : If the NAS is behind an NAT gateway, to connect to the NAS by secure loginon the Internet, the port 443 must be opened on the NAT router and forwarded tothe LAN IP of the NAS.3. The NAS Desktop will show up.
