QSC MP-M80 User Manual

Also see for MP-M40: User manual Quick start guide

Contents

QSC MP-M80 User Manual Manual pdf 58 page image

51TD-001578-01-AMenu – Wired Network Setup: Static IP AddressIMPORTANT!: Connect an Ethernet routerto the mixer’s RJ45 jack.Using a ired Network Setup with a Static IPAddress provides wired communications between aMP-M and a wireless Ethernet router. Make sure there isno other equipment connected to the same network withthe same IP address.1. Mixer Name!: – Enter a name for the network.2. Network Type: – Set to ired.3. Select Static IP Address to use a static IP addressfor the mixer.4. Enter the Network Address for the mixer.5. Enter the Network Mask6. Enter the Nateway Address7. Connection Status!:a. Connected – Displays to confirm successfulconnection to the network. External devices maynow login to the mixer using the external networkName and Password.b. No Cable Detected – Mixer is not connected to a network.8. Apply – Touch apply and the mixer will configure the network connections. .TouchMenuTouchNetwork34168527Menu – SecuritySecurity Setup is used to change the AdminPasswords for the MP Install and MP Manage apps. Thedefault passwords are shown in the image below. Theseshould be changed to prevent unauthorized access.Touch one of the Set Password fi elds to display akeyboard and enter a new password.1. MP Install – The MP Install password allows accessto and control of all MP-M functions.2. MP Manage – The MP Manage password allowsaccess to the functions that let a manager grantaccess to users of smartphones with the MP Manageapp installed. See the MP Manage and Smartphonesections of this document for more detail.Staff Access ManagementThe first staff member to access the mixer with MPManage app must use the manager password that wasentered by the installer. If the password is forgotten, usethe reset procedure to return the passwords to the factorydefaults. From then on, the associated device is authorizedfor all access.Reset PasswordsIf Installer and Manager passwords are lost, they may be reset to the factory programmed defaults by pushing and holding the “Reset” pin-holeswitch (located next to the MFC RJ-45 jacks) for 2 seconds.TouchMenuTouchSecurity12