QSC TouchMix-8 User Manual
Also see for TouchMix: Pocket reference guideApplication guideQuick start guideTechnical notesApplication guide
                                                                       | |
Contents
| 
46TD-000472-00-ABasic ChorusThe Chorus FX Varies the pitch of a signal at a steady rate to “thicken” a sound.Home FX Masters Select FXChannelEffectFX MastersFX 1 +FX ChorusSelect ChorusSelect Effect1. LFO Type Switch – Selects how the pitch will be varied. Sine will vary thepitch smoothly. Saw will cause the pitch to change abruptly and then rampback.2. LFO Rate Knob – Determines the rate at which the pitch will be varied.3. LFO Depth Knob – Controls the amount of modulation applied to theaudio signal.4. Lo Cut Knob – Attenuates, or “cuts” frequencies below this frequencysetting. Range is 20 Hz to 2 kHz.5. Hi Cut Knob – Attenuates, or “cuts” frequencies above this frequencysetting. Range is 200 Hz to 20 kHz.Pitch ShiftThe Pitch Shift raises or lowers the pitch of an audio signal by fixed interval. Inaddition, the signal can be delayed from the original. The two output channelscan be adjusted independently.Home FX Masters Select FXChannelEffectFX MastersFX 1 +FX Pitch ShiftSelectPitch ShiftSelect Effect1. Lo Cut Knob – Attenuates, or “cuts” frequencies below this frequencysetting. Range is 20 Hz to 2 kHz.2. Hi Cut Knob – Attenuates, or “cuts” frequencies above this frequencysetting. Range is 200 Hz to 20 kHz.3. Left and Right Shift Knobs – Sets the amount of shift, down (-) or up(+) for the two output channels.• 100¢ = 1 half step,• 200 ¢ = 1 whole step,• 1200¢ = 1 octaveRotating the Master Encoder will change the amount of pitch shift inhalf-step intervals. For finer adjustments, hold the Encoder down whileadjusting.4. Left and Right Delay Knobs – Adds up to 100 milliseconds of delay tothe Pitch Shift output.— Figure 43 —12 3 4 5— Figure 44 —1243 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine