1–Getting StartedConnecting the Management Workstation to the RouterISR654602-00 D 1-3Connecting the HardwareSANsurfer iSCSI/FC Router Manager requires an Ethernet connection to therouter using either of the following hardware configurations: Indirect Ethernet connection from the management workstation to the routerRJ-45 connector through an Ethernet switch or hub. This requires a 10/100Base-T straight cable. Direct Ethernet connection from the management workstation to the routerRJ-45 Ethernet connector. This requires a 10/100 Base-T crossover cable.For hardware configuration details, refer to the iSR6200 Intelligent Storage RouterInstallation Guide.Setting the Workstation IP AddressThe IP address of a new router is 10.0.0.1. To ensure that your workstation isconfigured to communicate with the 10.0.0 subnet, refer to the followinginstructions for your workstation.For a Windows workstation:1. On the Windows Start menu, point to Settings, point to Control Panel, andthen click Network and Dial-up Connections.2. Click Make New Connection.3. Click Connect to a private network through the Internet, and then clickNext.4. Type the new IP address; for example, 10.0.0.253.For a Linux or Solaris workstation:1. Open a command window.2. Enter the following commands, where (interface) is your interfacename:ifconfig (interface)ipaddress 10.0.0.253netmask 255.255.255.0Configuring the RouterTo configure an iSCSI port on a router blade, launch the General ConfigurationWizard using one of the following methods: On the Wizards menu, click Configuration Wizard. Press CTRL+G.
