Qlogic iSR6152 User Manual

Also see for iSR6152: Quick start guide

Contents

Qlogic iSR6152 User Manual Manual pdf 88 page image

3–Viewing Router InformationFCIP Routes3-42 ISR645610-00 B VLAN Enabled indicates whether the use of virtual LANs is enabled ordisabled. The default is Disabled. VLAN ID specifies the VLAN ID assigned to the FCIP route when VLAN useis enabled. The VLAN ID segregates traffic in a LAN, and must be the sameon both routers participating in the FCIP route (local and remote routersmust be using same VLAN ID) and on the Ethernet switches. VLAN Priority specifies the priority of the VLAN assigned to the FCIP routewhen VLAN use is enabled. In a network with multiple VLANs, the VLANPriority box prioritizes Ethernet traffic by giving higher preference to trafficin the network over non-VLAN traffic and traffic from VLANs with lowerpriorities. Level 1 is the lowest priority, level 7 is the highest priority, and level0 specifies no VLAN. Error Detect Timeout sets the error detect timeout value by selecting oneof five options: 1 to 5 seconds. The default is one second. Resource Allocate Timeout sets the resource allocate timeout value to oneof five options: 1 to 5 seconds. The default is one second. FCIP Timestamp enables or disables FCIP timestamps. The default isEnabled. FCIP SW Compression indicates whether software compression isenabled, disabled, or automatic (the default is Disabled). Depending on thedata, software compression may result in lower bandwidth operations. If thedata are highly compressible, the compressed FCIP PDU is significantlysmaller than the original Fibre Channel frame. Bandwidth (Mbit/sec) defines the maximum bandwidth (in megabits persecond) the GbE port will use during transmits. Supported values range from1 to 1000 Mbps. Use this setting to limit the bandwidth used by the FCIProute so it does not consume all the available link bandwidth. For example, ifthe slowest link in the WAN is a DS-3 link, the maximum available bandwidthis 45 megabits per second. To limit the FCIP route to 33 percent of theoverall link bandwidth, set the bandwidth to 15 megabits per second.StatisticsThe Statistics page for FCIP routes lists parameters and values, as shown inFigure 3-28. To update the statistics, click Refresh. To reset all values to zero,click Clear.